What are the steps of using Tank welding machine?

The gas-electric vertical welding used by tank welding machine is a fully automatic control ascending system with a special flux-cored wire, and CO2 gas shielding for vertical butt welding to weld vertical or near-vertical welded joints.

What is tank welding machine?

How many kinds of tank welding machine?

What is the preheating method of tank welding machine?

What is tank welding machine?

Large storage tank automatic welding machine, large storage tank is used to store oil, natural gas, and other energy. This kind of tank because the body is too big, cannot be formed at a time, are made of steel plate, splicing. So the welding machine is needed in the splicing process. Manual welding is the simplest and most direct method, but because of its high cost and low welding speed. So automation equipment has been widely used. Large tank automatic welding equipment, we are also known as tank automatic welding machine, the following for you to introduce several commonly used automatic welding machine: horizontal welding machine, vertical welding machine and Angle flat welding machine.

How many kinds of tank welding machine?

The so-called horizontal welding machine is a kind of welding machine that welds steel plates horizontally in the storage tank prefabrication.

The so-called vertical welding machine is a kind of welding machine that welds steel plates vertically in the storage tank prefabrication.

The so-called Angle flat welder is a welder that welds the bottom plate and the corners in the storage tank prefabrication.

What is the preheating method of tank welding machine?

After the arc of the welding rod of the tank welding machine is started, the arc is slightly elongated. In the state that the arc is not extinguished, the end of the welding rod is melted and a few droplets fall down. At this time, the welding rod has reached the normal burning state. At the same time, the use of the tank welding machine The heat generated by the arc heats the weld start. If it is found that the surface of the spot-fixed weld at the start of the weld begins to show signs of melting, the electrode will press the arc towards the lower edge of the spot-fixed weld, and then weld upward; The electrode reduces the welding speed slightly and turns the arc upwards. At this time, the electrode pauses for a while, and the rear edge of the weld joint is broken down in advance, and a molten pool and a molten hole are formed, and the formed molten hole must ensure that the blunt edge of both sides is 1.0~1.5 mm. At this time, the seam has been connected, and the electrode can be welded normally.

With a large number of suppliers, we can choose the right suppliers according to customers' requirements and provide the most cost-effective products. WINCOO ENGINEERING CO., LTD provides big pressure vessel, heavy duty pressure vessel, industrial pressure vessel, automatic pipeline construction equipment, electric vertical tank construction solution, etc. Complete after-sales service, we can provide online and offline technical support, not only video guidance, but also on-site guidance, want to know more about high efficiency pipeline construction equipment, horizontal pipeline construction equipment, stainless steel pressure vessel, etc.